EFTA00666782.pdf

From: Larry Visoski clia> To: Je vacation <jeevacation®gmail.com> Subject: Fwd: buzz on OW SN 1085 [1111722:740313] Date: Tue, 09 Jun 2015 20:37:25 +0000 Work recommendations from tech-support in Savannah, is it approved to comply with below ? Return to service 3pm tomorrow Thx Larry Sent from my iPhone Begin forwarded message: From: "Kessler, Barry" <1 Date: June 9, 2015 at 4:15:41 PM EDT To: "Visoski" Subject: buzz on GIV SN 1085 11111722:7403131 Larry, We have a couple of ideas. 1. Can be accomplished immediately: In the Engine Mount Vibration Isolator R&l there is a picture of what we affectionately call the dogbone. In the GIV AMM 71.01-00 page 401 is Engine Mount Vibration Isolators R & I (not using the MSG-3 AMM) for my reference. There is a picture of the dogbone on page 403. It is called "link" in the picture. This link while you are viewing the engine from the side with the upper cowl open, must not be leaning left or right, because it will be making contact with adjacent surface. It must be perfectly perpendicular so-to-speak. This link will stay where it was last positioned while the weight was off the engine with a crane. You will have to take the weight off the engine to move the link and make it straight so it is not leaning left or right touching the adjacent surface. Once you place the weight back on the engine, it will stay in place till next time. It will not move. 2. When your flight schedule permits; GIV AMM 71.00.00 bottom of page 601 begins Powerplant - Internal Inspection to page 604. This inspection will take care of inspecting fixed cowl (truly floating cowl) and other possible chaff areas. Even the jury struts (holds lower doors open) can contact the PLA transducers and cause a vibration, so check this as well. Make sure during the inspection of the floating cowl there is no sign of chaff anywhere on the floating cowl next to engine. As the engine spools up to power, it moves due to torque, and it may chaff at higher settings and not chaff when the power comes back. So if you see light during the inspection that is not good enough, it may be chaffing with the power forward and not chaffing when the power is back. The floating cowl chaff and the dogbone checks are first and foremost. Thank you, Barry Kessler Gulfstream Technical Operations Large Cabin Mechanical Systems EFTA00666782 (Direct) (Toll Free This e-mail message, including all attachments, is for the sole use of the intended recipient(s) and may contain Personal Information under General Dynamics policy CP 07-105 and/or legally privileged and confidential information. Any Personal Information can be accessed only by authorized personnel of General Dynamics and its approved service providers and may be used only as permitted by General Dynamics and its policies. Contractual restrictions apply to third parties. If you are not an intended recipient, you are hereby notified that you have either received this message in error or through interception, and that any review, use, distribution, copying or disclosure of this message or its attachments is strictly prohibited and is subject to criminal and civil penalties. All personal messages express solely the sender's views and not those of Gulfstream Aerospace Corporation. If you received this message in error, please contact the sender by reply e-mail and destroy all copies of the original message. EFTA00666783